HP 24S Guía de usuario descargar pdf (Pagina 35)

Configuration Commands

Several of the console commands allow you to customize the operation of your hub. They

are listed and described here.

Command Name Command Function

Factory Preset

Value

Backup

(HP 28688B and

HP 28699A only)

Configures one of the hub’s ports for

dedicated use in a backup (redundant) link

to another hub.

No backup link

configured.

IPconfig

(HP 28688B and

HP 28699A only)

Configures the hub to enable communication

with a network management station using

the Internet Protocol (IP).

IP communications

disabled.

Linkbeat

Enables or disables linkbeat on specific

twisted-pair port.

Linkbeat enabled.

(You must disable

linkbeat on every

twisted-pair port

connected to a non-

10Base-T device.)

Port Enables or disables specific hub ports. All ports enabled.

Thinwatch

Enables or disables Thinwatch. If

Thinwatch is enabled, the Fault LEDs and

ThinLAN port LED will flash if the

ThinLAN port becomes segmented.

Thinwatch disabled.

Note

Other console commands allow you to monitor the hub’s activity and to

diagnose hub and network problems. See chapter 3, “Operation”, for

console command details.

You can also receive information about a command at the console prompt

by entering HE (the Help command) followed by the first two characters of

the command, for example HE PO for help on the Port command.

Installation 2-17

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 101 102

Comentarios a estos manuales

Sin comentarios

HP 24S Guía de usuario Pagina 35

Comentarios a estos manuales

Relacionado con productos y manuales para Redes HP 24S