HP 24SII Manual de usuario descargar pdf (Pagina 76)

To access the configuration mode of the Model 24SII DES, use the

following procedure:

1. Connect a dumb terminal (or a PC running a terminal

emulation program) to the master configuration port

(Port 1 of Module 1) or to any serial computer port.

Configure your terminal's serial parameters to match

those of the Model 24SII DES. From the factory, all

serial ports on the Model 24SII DES are factory set at

9600 baud rate, 8 word size, 1 stop bit, no parity, and

XON/XOFF disabled.

If you do not have a dumb terminal or a terminal

emulation program, BayTech supplies a utility diskette

which includes software to put an IBM PC or compatible

into a terminal mode. See

Section 4.2

for instructions to

obtain the software (TERM.EXE) and

Section 4.6

for

instructions to use TERM for configuration.

2. Send from this device to the Model 24SII DES port being

used for configuration the following control characters:

ASCII Control-T (14 Hex), ASCII capital C (43 Hex),

and the desired module number (1 to 6).

For example, if your terminal is connected to Port 1 of Module

1 and you wish to configure a port on Module 1, you would

send the following: <Control-T>C1.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 167 168

Sin comentarios

HP 24SII Manual de usuario Pagina 76