
Troubleshooting
1-12
HP DesignJets 500, 510 and 800 Series Printers Service Manual
the Interconnect Cable. Try the following:
1 Check that the Interconnect Cable is connected correctly to the
Electronics Module and to the Interconnect PCA.
2
If the Interconnect cable is connected correctly and the LED continues
to flash twice then replace the Interconnect Cable
⇒
Page
8-59
.
LED Flashes 3 times every few seconds - The Printer cannot
detect the Front Panel. Try the following:
1 Check that the Front Panel is connected correctly to the Interconnect
PCA.
2 Check that the Interconnect Cable is properly connected at the both
ends of the Printer.
3 If the Front Panel is connected correctly and the LED continues to
flash 3 times then replace the Front Panel ⇒ Page 8-9.
4 R
eplace the Interconnect Cable
⇒
Page
8-59
.
5
Replace the Electronics Module
⇒
Page
8-24
.
LED Flashes 4 times every few seconds
- This indicates that the
Main PCA has failed. Replace the Electronics Module
⇒
Page
8-24
.
LED Flashes 5 times every few seconds
- This indicates that the
Main PCA has failed. Replace the Electronics Module
⇒
Page
8-24
.
Comentarios a estos manuales