HP CH336A#B1K Manual de usuario Pagina 40

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 285
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 39
System Error Codes
2-13
HP DesignJets 500, 510 and 800 Series Printers Service Manual
System Error: 56:10
Problem
Description:
Drive Roller Encoder Sensor error.
Corrective Action: Try the following:
Replace the Drive Roller Encoder Sensor Page 8-38.
If the problem persists, replace the Encoder Disk Assembly.
System Error: 56:13
Problem
Description:
Error in the Drive Roller Encoder Sensor quadrature.
Corrective Action: Try the following:
Switch the Printer Off and wait a few minutes. Switch the Printer
On again and check if the Error Code has disappeared.
If the Error Code continues, replace the Drive Roller Encoder
Sensor Page 8-38.
System Error: 61:04
Problem
Description:
Firmware Error.
Corrective Action: Try the following:
Switch the Printer Off and wait a few minutes. Switch the Printer
On again and check if the Error Code has disappeared.
If the Error Code reappears, check for a new Firmware release.
If the new Firmware release does not solve the problem, or if new
Firmware release was not available, then contact the HP
Response Center (or directly to the Division) supplying the
following information:
– Model and Serial Number of the Printer.
– Firmware release of the Printer (use the Printer Information
utility
Page
4-27
).
– The complete Error Code information, including the linefeed
where the error occurred (use the Error Log utility to obtain this
information
Page
2-5
).
Vista de pagina 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 284 285

Comentarios a estos manuales

Sin comentarios