HP DesignJet ColorPro CAD Manual de usuario Pagina 151

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 262
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 150
Removal and Replacement of Parts (without Calibration) 7-1
Chapter 7 Removal and Replacement of Parts (without
Calibration)
This chapter describes how the printer can be disassembled for repair and maintenance. This section covers
the removal of parts that can be reassembled without calibration. To reassemble the printer, reverse the order
of the procedure. Where required, additional explanation will also be provided for any special adjustments or
procedure steps (such as instances where reassembly differs from disassembly).
You should also take note that it may not be necessary to disassemble the printer to service certain
components.
Removal and Replacement Tools
To disassemble the printer, you will need the following tools :
1. A TORX
screwdriver with T-10 and T-20 screw bits.
2. Needle nose pliers.
3. Straight tweezers.
4. A flat-blade screw driver (Philips no.1 or flathead no.5).
5. Instruction manual.
It is strongly recommended that proper tools (including screws) be used for the job.
www.GovTechMedia.com
Vista de pagina 150
1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 261 262

Comentarios a estos manuales

Sin comentarios