HP DesignJet ColorPro CAD Manual de usuario descargar pdf (Pagina 154)

Removal and Replacement of Parts (without Calibration)7-4

Replacement of Parts

Replacement of PCA

You will be removing the PCA from the printer and installing a new PCA.

Removing the PCA

Step 1. Lift the two latches on both the right top

and left top corners of the rear access door

to unlatch it.

Step 2. If you have any peripheral accessory (e.g.

MIO network card), remove it by

loosening the two screws on the card and

slide it out from the right side of the rear

access door. Set the card aside.

Step 3. Unscrew the four screws on the metal

PCA cover and set them aside. Remove

the PCA cover.

Step 4. Unplug all connectors (two in black and

two in grey) and the power connector

(blue) from the main PCA.

Step 5. Carefully remove the two flex cables from

the main PCA by lifting the black plastic

fastener at both ends and sliding the flex

out.

www.GovTechMedia.com

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 261 262

Sin comentarios

HP DesignJet ColorPro CAD Manual de usuario Pagina 154