
Removal and Replacement of Parts (with Calibration) 10-35
Step 9. Remove two screws from the top of the
print carriage. The top of the carriage
folds open backwards.
Step 10. Carefully remove the two flex
connectors from the PCA by lifting the
black plastic fastener at both ends and
sliding the connectors out. If required,
unfasten the plastic retainer gently using
a pair of tweezers.
Step 11. Slide the flex cable out through the slots
on the carriage chassis assembly and
detach from the printer.
www.GovTechMedia.com
Comentarios a estos manuales