HP DesignJet ColorPro CAD Manual de usuario descargar pdf (Pagina 224)

Removal and Replacement of Parts (with Calibration)10-6

Replacement of Parts

Installing the Assembly Platen

Step 1. Install the assembly platen by sliding it inwards from the right.

Step 2. Reconnect the two connectors on the right.

Step 3. Slide the left plastic bearing in and snap it into position ; replace the right bearing.

Step 4. Replace the upper feed guides.

Step 5. Replace the service station.

Step 6. Replace the sensor assembly harness connector, fan motor connector and top cover sensor.

Step 7. Reattach the bracket encoder and fasten it with two screws.

Step 8. Reattach MIDS by refastening the MIDS tube clip to the carriage chassis assembly and replacing

the center screw between the letters C and M on the print carriage.

Step 9. Replace the remaining components for the Main Case (refer to the procedures in Installing the

Main Case from Replacement of Main Case).

www.GovTechMedia.com

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 261 262

Sin comentarios

HP DesignJet ColorPro CAD Manual de usuario Pagina 224