Hp ProCurve 520wl Wireless Access Point Manual de usuario descargar pdf (Pagina 17)

Figure 2-3

Figure 2-3Figure 2-3

Configuration through the Web Interface

Configuration through the Web Interface Configuration through the Web Interface

Figure 2-4

Figure 2-4Figure 2-4

Configuration Options

Configuration Options Configuration Options

OKOK

C nc

CancelCancel

2 3

Figure 2-3 Configuration through the Web Interface

You are now ready to configure each WL520 category, depending on your system. In some cases, you will not need to make

any changes. If you are in doubt about any setting, we recommend that you use the default values.

Figure 2-4 Configuration Options

To set properties for each category, click on the desired tab.

Result: The selected configuration screen appears. Each configuration screen allows you to select options, or enter, edit, and

delete information.

In some cases, the WL520 reminds you that it must be rebooted for a change to take effect. In a given session, you can wait to

reboot until all changes have been made. After entering or editing information on configuration screens, click OK to save

changes, or click Cancel to restore previous settings.

a el

You will want to set up a few basic configuration parameters right away when you receive the WL520 unit. For example:

– System name and location

– Contact information for network administrator

– IP Address

– Communication rules for your wireless interface(s)

– Passwords for the different management interfaces (SNMP, Telnet, HTTP)

– If you need to upload the latest software, you will also want to setup your TFTP server to communicate with the WL520

device. This process is described in downloading the latest software, under

Setup your TFTP Server.

2-4

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 141 142

Sin comentarios

Hp ProCurve 520wl Wireless Access Point Manual de usuario Pagina 17