Hp ProCurve 520wl Wireless Access Point Manual de usuario descargar pdf (Pagina 81)

Recovery Procedures

5-7

initializing the ip address using normal cli

initializing the ip address using normal cliinitializing the ip address using normal cli

initializing the ip address using normal cli

After installing the serial port cable, you may use the CLI to communicate with the WL520. You may use most generic terminal

programs, such as HyperTerminal. Once the IP Address has been assigned, use the HTTP Interface or the CLI to complete

configuration. Many web sites offer shareware or commercial terminal programs you can download.

Use the following procedure to initialize the WL520 IP Address.

1. Open your terminal emulator, and then set the following connection properties:

Q Com Port: <COM1, COM2, etc., depending on your computer>

Q Baud rate: 9600

Q Data Bits: 8

Q Stop bits: 1

Q Flow Control: None

Q Parity: None

2. Enable the “ASCII Setup” settings by selecting “Send line ends with line feeds”. Result: HyperTerminal sends a line return at

the end of each line of code.

3. Press the

RESET

RESETRESET

RESET button on the WL520 (located on the LED Indicator side of the unit). Result: The terminal display shows

Power On Self Tests (POST) activity, and then displays a CLI prompt, similar to the example below. This process may take

up to 90 seconds.

[Device name]>

Please enter password:

Please enter password: Please enter password:

Please enter password:

4. Enter the password (default is "public"). Result: The terminal displays a welcome message and then the CLI Prompt:

[Device name]

5. Enter show ip. Result: Network parameters appear:

[Device name]>

show ip

Figure 5-1

Figure 5-1Figure 5-1

Figure 5-1

Result of “show ip” bootloader CLI command

Result of “show ip” bootloader CLI commandResult of “show ip” bootloader CLI command

Result of “show ip” bootloader CLI command

6. Change the IP Address and other network values using set

setset

set and reboot

rebootreboot

reboot CLI commands, similar to the example dialog below

(use your own IP Address and IP Mask). Result: After each entry the CLI reminds you to reboot; however wait to reboot

until all commands have been entered.

[Device name]>

set ipaddrtype static

[Device name]>

set ipaddr <IP Address>

[Device name]>

set ipsubmask <IP Mask>

[Device name]>

set ipgw <Default Gateway IP Address>

[Device name]>

reboot 0

7. After the WL520 reboots, verify the new IP Address by reconnecting, and then entering a

show ip

show ipshow ip

show ip CLI statement (as in Step

5). Alternatively, you can use the

ping

pingping

ping network command from networked computers to test the new IP Address.

8. When the proper IP Address is set, use CLI or the HTTP Interface over the LAN to complete configuration and manage

operations.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 141 142

Comentarios a estos manuales

Sin comentarios

Hp ProCurve 520wl Wireless Access Point Manual de usuario Pagina 81

Comentarios a estos manuales

Relacionado con productos y manuales para Routers Hp ProCurve 520wl Wireless Access Point