HP ProLiant DL140 Guía de instalación descargar pdf (Pagina 23)

HP ProLiant DL140 Server Setup and Installation Guide 15

Installing ATA Hard Drives

This server model is designed to support two 1-inch ATA hard drives.

When installing ATA hard drives, observe the following guidelines:

• Access internal server components. Refer to the “Accessing Internal Server Components”

section earlier in this chapter.

• Always populate hard drive bays starting with the lowest ATA device number.

• Verify the jumpers on both ATA drives are set to Cable-Select mode. Doing so enables the

ATA cable to set a unique address, such as Device 0 or Device 1, for each hard drive.

CAUTION: Installing unsupported hard drives may damage the system by

consuming power and generating heat in excess of the server’s operating tolerance.

This condition may result in a loss of system and/or data integrity.

CAUTION: Whenever installing hardware or performing maintenance procedures

requiring access to internal components, it is recommended that all server data be

backed up to avoid loss.

• Identify the hard drive tray for ATA hard drive installation. ATA hard drives in the server

appear as Devices 0 and 1, from right to left when viewed from the front of the server. Refer

to Figure 3-11.

To remove an ATA hard drive tray:

1. Loosen the bracket screw (1) and remove the hard drive tray (2).

2. Remove the four ATA hard drive mounting screws (3) from the hard drive tray.

Figure 3-8: Removing the ATA hard drive tray

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

Sin comentarios

HP ProLiant DL140 Guía de instalación Pagina 23