HP ProLiant DL140 Guía de instalación descargar pdf (Pagina 25)

HP ProLiant DL140 Server Setup and Installation Guide 17

4. Connect the ATA hard drive cable as shown below.

Figure 3-11: Cabling the ATA hard drives

5. Connect the ATA hard drive power cable to the ATA hard drives.

IMPORTANT: Make sure the ATA hard drive cables are routed so as to not block airflow

to the fan inlets.

6. Replace the access panel.

Installing a CD-ROM Drive Assembly

CAUTION: Do not operate the server without a bezel blank or the CD-ROM drive

assembly installed. Improper cooling can damage the system.

To Remove the CD-ROM tray from the chassis:

1. Press in and hold the CD-ROM latch (1).

2. Slide the tray toward the rear of the server until the USB connectors are visible (2).

3. Lift the CD-ROM tray out of the server (3).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Sin comentarios

HP ProLiant DL140 Guía de instalación Pagina 25