HP Switch 6208M-SX Manual de usuario Pagina 507

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 710
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 506
Advanced Configuration and Management Guide
Table 12.1: VRRP and VRRPE Parameters (Continued)
Track priority A VRRP or VRRPE priority value assigned to the
tracked port(s). ked ports link goes down, the
VRID ports VRRP or VRRPE priority changes.
VRRP The priority changes to the value of the
tracked ports priority.
VRRPE The VRID ports priority is reduced by
the amount of the tracked ports priority.
VRRP 2
VRRPE 5
12-5
12-17
Backup preempt
mode
Prevents a Backup with a higher VRRP priority from
taking control of the VRID from another Backup that
has a lower priority but has already assumed control
of the VRID.
Enabled 12-18
Parameter Description Default See page...
If a trac
Configuring Basic VRRP Parameters
To implement a simple VRRP configuration using all the default values, enter commands such as the following.
Configuring the Owner
Router1(config)# router vrrp
Router1(config)# inter e 1/6
Router1(config-if-1/6)# ip address 192.53.5.1
Router1(config-if-1/6)# ip vrrp vrid 1
Router1(config-if-1/6-vrid-1)# owner
Router1(config-if-1/6-vrid-1)# ip-address 192.53.5.1
Router1(config-if-1/6-vrid-1)# activate
Configuring a Backup
Router2(config)# router vrrp
Router2(config)# inter e 1/5
Router2(config-if-1/5)# ip address 192.53.5.3
Router2(config-if-1/5)# ip vrrp vrid 1
Router2(config-if-1/5-vrid-1)# backup
Router2(config-if-1/5-vrid-1)# ip-address 192.53.5.1
Router2(config-if-1/5-vrid-1)# activate
Configuration Rules for VRRP
The interfaces of all routers in a VRID must be in the same IP sub-net.
The IP address(es) associated with the VRID must already be configured on the router that will be the Owner
router.
An IP address(es) associated with the VRID must be on only one router.
The Hello interval must be set to the same value on both the Owner and Backup(s) for the VRID.
The Dead interval must be set to the same value on both the Owner and Backup(s) for the VRID.
The track priority on a router must be lower than the routers VRRP priority. Also, the track priority on the
Owner must be higher than the track priority on the Backup(s).
12 - 12
Vista de pagina 506
1 2 ... 502 503 504 505 506 507 508 509 510 511 512 ... 709 710

Comentarios a estos manuales

Sin comentarios