HP EliteDesk 800 G2 Small Form Factor PC Manual de usuario descargar pdf (Pagina 46)

Installing a 9.5 mm slim optical drive

1. Prepare the computer for disassembly (Preparation for disassembly on page 18).

2. Remove the access panel (Access panel on page 19).

3. Remove the front bezel. If you are installing a drive in a bay covered by a bezel blank, then remove the

bezel blank. See Front bezel on page 19 for more information.

4. Align the small pin on the release latch with the small hole on the side of the drive and press the latch

rmly onto the drive.

5. Slide the optical drive through the front of the chassis all the way into the bay so that it locks in place

(1), and then connect the power cable (2) and data cable (3) to the rear of the drive.

6. Connect the opposite end of the data cable to one of the light blue SATA connectors on the system

board.

NOTE: Refer to System board connections on page 32 for an illustration of the system board drive

connectors.

36 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 153 154

Sin comentarios

HP EliteDesk 800 G2 Small Form Factor PC Manual de usuario Pagina 46