HP EliteDesk 800 G2 Small Form Factor PC Manual de usuario Pagina 62

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 154
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 61
Hood sensor
The hood sensor is attached to the rear of the chassis.
1. Prepare the computer for disassembly (Preparation for disassembly on page 18).
2. Remove the access panel (Access panel on page 19).
3. Rotate the small bae into the upright position (Small bae on page 48).
4. Disconnect the hood sensor cable from the system board connector labeled HSENSE.
5. Slide the hood sensor out of the slot on the rear of the chassis (2). A tool such as a screwdriver may be
required to disengage the hood sensor from the slot.
To install the hood sensor, reverse the removal procedure.
52 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
Vista de pagina 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 153 154

Comentarios a estos manuales

Sin comentarios