HP EliteDesk 800 G2 Small Form Factor PC Manual de usuario descargar pdf (Pagina 54)

5. Pull outward on the release lever at the rear of the drive (1) then slide the drive back until it stops and

pull it down and out of the drive bay (2).

6. If you are installing a new drive, refer to Installing a 2.5-inch hard drive on page 44. If you are not

installing a new drive, rotate the drive cage down and replace the access panel.

Installing a 2.5-inch hard drive

1. Prepare the computer for disassembly (Preparation for disassembly on page 18).

2. Remove the access panel (Access panel on page 19).

3. Install four black and blue M3 isolation mounting guide screws (two on each side of the drive).

NOTE: M3 metric isolation mounting guide screws can be purchased from HP.

When replacing a drive, transfer the four mounting screws from the old drive to the new drive.

44 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 153 154

Sin comentarios

HP EliteDesk 800 G2 Small Form Factor PC Manual de usuario Pagina 54