Hp 9000 rp5400 Servers Manual de usuario descargar pdf (Pagina 100)

Extend the Server out the Front

rp54xx servers are available in two housings: rack-mounted or stand-alone. Access to servers

mounted in an HP-supported rack is covered in this section.

WARNING! Ensure that all anti-tip features (front and rear anti-tip feet installed; adequate

ballast properly placed, etc.) are employed prior to extending the server.

NOTE: Ensure that there is enough area (Approximately 1.5 meters (4.5 ft) to fully extend the

server out the front and work on it.

To extend the server, perform the following steps:

1. Remove the four T-25 screws that fasten the server to the rack.

2. Grasp the server chassis and slowly pull forward. The server is fully extended when the rail

clips are locked in place. When fully extended, the top and side service bays are fully

accessible.

The following graphic shows the server extended and indicates the rail clip location.

Insert the Server from the Front

rp54xx servers are available in two housings: rack-mounted or stand-alone. Access to servers

mounted in an HP-supported rack is covered in this section.

To return the server into the rack, press the rail clips on either side of the server in and push the

server into the rack until it stops.

The following graphic shows the server extended and indicates the rail clip location.

Stand-alone Server Cover Removal

The rp54xx server can be ordered as a stand-alone unit. In this configuration, the server has a

one-piece protective cover over it and sits on a platform with locking wheels attached.

To remove the cover from a stand-alone server, perform the following procedures:

100 Removing and Replacing Components

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 162 163

Sin comentarios

Hp 9000 rp5400 Servers Manual de usuario Pagina 100