Hp ProLiant DL365 Server Manual de usuario Pagina 71
- Pagina / 116
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Configuration and utilities 71
Safety and security benefits
When you flash the system ROM, ROMPaq writes over the backup ROM and saves the current ROM as a
backup, enabling you to switch easily to the alternate ROM version if the new ROM becomes corrupted
for any reason. This feature protects the existing ROM version, even if you experience a power failure
while flashing the ROM.
Access to redundant ROM settings
To access the redundant ROM through RBSU:
1. Access RBSU by pressing the F9 key during powerup when the prompt is displayed in the upper
right corner of the screen.
2. Select Advanced Options.
3. Select Redundant ROM Selection.
4. Select the ROM version.
5. Press the Enter key.
6. Press the Esc key to exit the current menu or press the F10 key to exit RBSU. The server restarts
automatically.
To access the redundant ROM manually:
1. Power down the server (on page 18).
2. Remove the access panel (on page 20).
3. Set positions 1, 5, and 6 of the system maintenance switch to On.
4. Install the access panel (on page 20).
5. Power up the server (on page 18).
6. Wait for the server to emit two beeps.
7. Repeat steps 1 and 2.
8. Set positions 1, 5, and 6 of the system maintenance switch to Off.
9. Repeat steps 4 and 5.
When the server boots, the system identifies whether the current ROM bank is corrupt. If a corrupt ROM is
detected, the system boots from the backup ROM and alerts you through POST or IML that the ROM bank
is corrupt.
If both the current and backup versions of the ROM are corrupt, the server automatically enters ROMPaq
disaster recovery mode.
USB support
HP provides both standard USB support and legacy USB support. Standard support is provided by the
operating system through the appropriate USB device drivers. HP provides support for USB devices prior
to the operating system loading through legacy USB support, which is enabled by default in the system
ROM. HP hardware supports USB version 2.0.
Legacy USB support provides USB functionality in environments where USB support is normally not
available. Specifically, HP provides legacy USB functionality at:
• POST
• RBSU
• Diagnostics
• DOS
• Environments which do not support USB natively
- HP ProLiant DL365 Server 1
- User Guide 1
- Audience assumptions 2
- Contents 3
- Contents 4 4
- Contents 5 5
- Contents 6 6
- Component identification 7
- Front panel LEDs and buttons 8
- Rear panel components 9
- Rear panel LEDs and buttons 10
- System board components 11
- System maintenance switch 12
- NMI jumper 12
- SAS and SATA device numbers 14
- SAS and SATA hard drive LEDs 15
- Fan locations 16
- Operations 18
- Remove the access panel 20
- Install the access panel 20
- Operations 23 23
- In this section 24
- Rack planning resources 25
- Optimum environment 25
- Temperature requirements 26
- Power requirements 26
- Rack warnings 27
- Installing hardware options 27
- Registering the server 30
- Introduction 31
- Processor option 31
- Memory options 36
- Memory configurations 37
- Advanced ECC memory 37
- Installing DIMMs 37
- Removing hard drive blanks 39
- Multibay device options 41
- Expansion board options 44
- P400i Controller 48
- Cabling 61
- Cabling 62 62
- Battery pack cabling 63
- Multibay backplane cabling 64
- Configuration and utilities 65
- HP ROM-Based Setup Utility 66
- Array Configuration Utility 67
- Management tools 69
- Erase Utility 70
- Management Agents 70
- HP Systems Insight Manager 70
- Redundant ROM support 70
- USB support 71
- Diagnostic tools 72
- HP Insight Diagnostics 73
- Integrated Management Log 73
- Keeping the system current 74
- Care Pack 75
- Troubleshooting 76
- Symbols on equipment 77
- Warnings and cautions 77
- Symptom information 78
- Loose connections 79
- Service notifications 79
- Troubleshooting flowcharts 80
- General diagnosis flowchart 81
- Symptoms: 83
- Troubleshooting 85 85
- POST problems flowchart 86
- OS boot problems flowchart 87
- Troubleshooting 89 89
- Possible causes: 90
- Redundancy failure 90
- Troubleshooting 91 91
- Battery replacement 92
- FCC rating label 93
- FCC logo, United States only 94
- Modifications 95
- Japanese notice 96
- BSMI notice 96
- Korean notice 97
- Laser compliance 97
- Battery replacement notice 97
- Electrostatic discharge 99
- Specifications 100
- Technical support 102
- Technical support 103 103
- Customer Self Repair 104
- Reparo feito pelo cliente 106
- Technical support 107 107
- Technical support 108 108
- Technical support 109 109
- Acronyms and abbreviations 110
- Index 114 114
- Index 115 115
- Index 116 116
Relacionado con productos y manuales para Hardware De La Computadora Hp ProLiant DL365 Server
(107 paginas)
(187 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.020 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales