
25
• link-agg - Link Aggregation mode
• balance-alb - Adaptive load balancing
• link-agg-layer2+3 - Link aggregation layer 2 + 3 mode
• backup - Active/Backup mode
The above commands perform the bonding of Ethernet ports eth1 and eth2 to create the bonded
port eth0 and then saves the configuration changes. For many switches, if ‘balance-rr’ mode is used,
explicit switch port trunking of the bonded gateway ports is not needed; however, if any of the other
link aggregation modes are used, you will need to have configured port trunking on the switches
accordingly.
*hp-gateway1 [hp-redundant1: master] (config) # network bond eth0 mode balance-rr
interface eth1 interface eth2
Are you sure you wish to change networking modes? All cached content will be
lost, the cache modules will leave the cluster to set up networking, and remote
cli connections may be terminated. Continue? [no] yes
*hp-gateway1 [hp-redundant1: unknown] (config) #
*hp-gateway1 [hp-redundant1: unknown] (config) # write memory
hp-gateway1 [hp-redundant1: master] (config) # show network
Networking configuration:
Bonded interface eth0:
Enabled: yes
Interfaces:
eth1
eth2
Jumbo frames:
Enabled: no
Interfaces:
eth0 (mtu: 1500)
eth1 (mtu: 1500)
eth2 (mtu: 1500)
eth3 (mtu: 1500)
eth4 (mtu: 1500)
eth5 (mtu: 1500)
eth6 (mtu: 1500)
eth7 (mtu: 1500)
eth8 (mtu: 1500)
Global default-gateway:
Enabled: yes
Address: 10.61.184.1
Global mtu:
Enabled: yes
Global VLANs:
Enabled: yes
Interfaces:
hp-gateway1 [hp-redundant1: master] (config) #
Configure Inter-Gateway VLAN on Primary Gateway
Next, create the VLAN on the primary gateway which will be used for inter-gateway communication
and heartbeat.
To create a VLAN using the VLAN-id previously planned in the ‘Define Network IP Addressing Plan’
section and created on the Ethernet switches, use the following commands:
Comentarios a estos manuales