HP VMA-series Memory Arrays Manual de instalación descargar pdf (Pagina 26)

# network vlan vlan-id <vlan-id> interface eth0

# interface vlan# zeroconf

Where <vlan-id> is the VLAN ID instance number between 1 and 4094 to be created atop the newly

created bonded interface, eth0. The interface created will be named vlan#, where # is the VLAN ID

instance number used, such as vlan14.

*hp-gateway1 [hp-redundant1: master] (config) # network vlan vlan-id 14 interface

eth0

*hp-gateway1 [hp-redundant1: master] (config) # interface vlan14 zeroconf

*hp-gateway1 [hp-redundant1: master] (config) # show network

Networking configuration:

Bonded interface eth0:

Enabled: yes

Interfaces:

eth1

eth2

Jumbo frames:

Enabled: no

Interfaces:

eth0 (mtu: 1500)

eth1 (mtu: 1500)

eth2 (mtu: 1500)

eth3 (mtu: 1500)

eth4 (mtu: 1500)

eth5 (mtu: 1500)

eth6 (mtu: 1500)

eth7 (mtu: 1500)

eth8 (mtu: 1500)

Global default-gateway:

Enabled: yes

Address: 10.61.184.1

Global mtu:

Enabled: yes

Global VLANs:

Enabled: yes

Interfaces:

vlan14 (id: 14, if: eth0)

*hp-gateway1 [hp-redundant1: master] (config) #

Next, set the gateway cluster interface to be the VLAN created above:

# cluster interface vlan# <where # is the VLAN-ID #>

# write memory

Refer to the ‘VLAN Cluster Interface’ section of the ‘HP VMA SAN Gateway Installation and

Configuration Guide’ for additional details and examples.

*hp-gateway1 [hp-redundant1: master] (config) # cluster interface vlan14

*hp-gateway1 [hp-redundant1: *unknown*] (config) # show network

Networking configuration:

Bonded interface eth0:

Enabled: yes

Interfaces:

eth1

eth2

Jumbo frames:

Enabled: no

Interfaces:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 44 45

Comentarios a estos manuales

Sin comentarios

HP VMA-series Memory Arrays Manual de instalación Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores HP VMA-series Memory Arrays