HP ProDesk 600 G3 Base Model Small Form Factor PC Manual de usuario descargar pdf (Pagina 57)

Power supply

Description

Power supply, 180W, 92% ecient

Power supply, 180W, 85% ecient

WARNING! To reduce potential safety issues, only the power supply provided with the computer, a

replacement power supply provided by HP, or a power supply purchased as an accessory from HP should be

used with the computer.

The power supply is located at the rear of the chassis. It is held in place by three Torx screws outside of the

chassis and a release lever inside of the chassis.

WARNING! Voltage is always present on the system board when the computer is plugged into an active AC

outlet. To avoid possible personal injury and damage to the equipment the power cord should be

disconnected from the computer and/or the AC outlet before opening the computer.

1. Prepare the computer for disassembly (Preparation for disassembly on page 20).

2. Remove the access panel (Access panel on page 21).

3. Remove the drive cage (Drive cage on page 25).

4. From the outside, rear of the computer, remove the four Torx T15 screws that secure the power supply

to the rear of the chassis.

5. From the inside of the chassis, disconnect all power cables from the PWR (1) and PWRCMD (2) system

board connectors.

6. Press the release button at the front of the power supply (3).

Power supply 49

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 149 150

Sin comentarios

HP ProDesk 600 G3 Base Model Small Form Factor PC Manual de usuario Pagina 57