HP B8C95AA Manual de usuario descargar pdf (Pagina 124)

100

101

Service Tests and Utilities

3-16 HP Designjet T Series — Service Manual

35 Press any key to shutdown the printer.

Cutter test

The Cutter is designed to cut roll media after printing for the size of sheet

def

ined. Before executing this test you should run the Scan Axis, Media Drive

and Carriage tests to ensure that each of these subsystems is operating

correctly.

Perform the Scan Axis - Cutter test as follows:

1 In the Diagnostics menu, scroll to 1. S

can Axis and press OK.

2 The Front Panel will show the 1. Scan Axis submenu.

3 In the Scan Axis submenu, scroll to Cutter and press OK to start the test.

The Printer will start the Scan Axis subsystem Common Initialization and

Cut

ter test initialization. If there is a Failure at any point during the tests, the

Front Panel will display the relevant System Error Code. To trouble shoot

any displayed error codes, see

System Error Codes - Full Descriptions on

page 2-7.

4 The printer then starts the Cutter test to verify the subsystem. As the test

ecutes the Front Panel displays the following messages:

 Starting Horsburgh and Mips.

 Starting Nvm.

 Starting TestsGpio.

 Getting Part Number.

 Starting SvsMotor.

 Starting CarriageMotor.

 Starting ServiceStation.

 Starting ScanAxis

 Moving SVS to rear bump.

 Homing Scan Axis.

 Move Carriage out of SVS path.

 Homing Service Station.

 Starting ServicingServices.

 Capping Service Station.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 489 490

Comentarios a estos manuales

Sin comentarios

HP B8C95AA Manual de usuario Pagina 124

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo HP B8C95AA