
Operate the All-in-One
25
Scan
Scan instructions – Hand mount configuration
The All-in-One can scan most one-dimensional and two-dimensional bar code symbologies. See
“All-in-One Specifications” for a complete list.
1. Aim the green light bar at the bar code.
2. Hold the All-in-One 6 - 9 inches from the bar code.
3. Hold the All-in-One at a slight angle (approximately 5 degrees) to the scan surface.
NOTE: Hold steady for best results.
When the scan is complete, the imager light will turn off, and the All-in-One will emit a Hi tone.
When the All-in-One is ready to print, it will display green tail lights and emit a Hi tone.
Comentarios a estos manuales