HP Modular Smart Array 500 Starter Kit Guía de usuario Pagina 125

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 186
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 124
HP StorageWorks 2300 Modular Smart Array CLI reference guide 125
show enclosure-status
Description Shows the status of system enclosures and their components. For each attached enclosure, the
command shows general SCSI Enclosure Services (SES) information followed by component-specific
information.
Syntax
show enclosure-status
Output General SES fields:
Chassis
Chassis serial number
Vendor
Enclosure vendor name
Product ID
Product model identifier
CPLD
Complex Programmable Logic Device version
EMP # BUS:ID Rev
Address and firmware revision of the Enclosure Management Processor in each controller's
Expander Controller
WWPN
World wide port name of the SES device reporting the enclosure status
Status
Overall status of the enclosure
Health
Overall health of the enclosure: OK, Degraded, Fault, or Unknown
Enclosure Component Status fields:
Type
Component type:
FAN: Cooling fan unit
PSU: Power supply unit
Temp: Temperature sensor
Voltage: Voltage sensor
Disk: Disk drive module
#
Unit ID
Status
Component status:
Absent: The component is not present.
Fault: The component or at least one subcomponent has failed.
Degraded: The component or at least one subcomponent is not working normally.
OK: The component and any subcomponents are working normally. Temperature status OK
indicates that the sensor is working properly, not that the temperature is within an acceptable
range.
N/A: Status is not available.
FRU P/N
Part number of the field-replaceable unit (FRU) that contains the component
FRU S/N
Serial number of the FRU that contains the component
Vista de pagina 124
1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 185 186

Comentarios a estos manuales

Sin comentarios