Hp Hitachi Dynamic Link Manager Software Manual de usuario Pagina 240

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 492
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 239
6. Command Reference
216
sure that you use the view operation to find the current AutoPATH_ID of the
target path, before executing the
offline operation.
Example
The following example shows how to place offline all the paths connected to
the channel adapter port
0A. In this example, a path whose AutoPATH_ID is
000001 is connected to the target channel adapter port:
>dlnkmgr offline -cha -pathid 000001
KAPL01055-I All the paths which pass the specified CHA
port will be changed to the Offline(C) status. Is this
OK? [y/n]:y
KAPL01056-I If you are sure that there would be no problem
when all the paths which pass the specified CHA port are
placed in the Offline(C) status, enter y. Otherwise,
enter n. [y/n]: y
KAPL01061-I 2 path(s) were successfully placed
Offline(C); 0 path(s) were not. Operation name = offline
>
-pathid
AutoPATH_ID
Use this parameter to place a single path offline.
Specify the current AutoPATH_ID of the target path, which is displayed by using
the
view operation. For details about the view operation, see 6.7 view (Displays
Information). Leading zeros can be omitted (
000001 and 1 indicate the same
AutoPATH_ID); however, when the target AutoPATH_ID is
000000, enter
000000 or 0 for the parameter value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always make
sure that you use the
view operation to find the current AutoPATH_ID of the
target path, before executing the
offline operation.
-hbaportwwn HBA-port-WWN [-tid target-ID -hlun host-LU-number]
Use this parameter to place offline all paths connected to the HBA port indicated
by the specified HBA port WWN. If niether the
-tid parameter nor the -hlun
parameter are specified, all paths that pass through the specified HBA port WWN
will be placed offline. Only one set of values can be specified for the
-hbaportwwn parameter.
For HBA-port-WWN, specify the value of
HBAPortWWN. The parameter is not
case sensitive.
For target-ID, specify the target ID portion of
PathName. Leading zeroes can be
omitted from the target ID (
0000000000000001 and 1 are the same value). The
parameter is not case sensitive.
Vista de pagina 239
1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 491 492

Comentarios a estos manuales

Sin comentarios