HP ElitePad 1000 G2 Tablet Manual de usuario descargar pdf (Pagina 51)

2. Release the ZIF connector (1) to which the forward-facing webcam cable is attached, and then

disconnect the forward-facing webcam cable (2) from the system board.

3. Remove the forward-facing webcam and cable.

Reverse this procedure to install the forward-facing webcam.

Slot cover

NOTE: The slot cover is included in the Button Kit, spare part number 747634-001.

Before removing the slot cover, follow these steps:

1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and

then shut it down through the operating system.

2. Disconnect the power from the tablet by unplugging the power cord from the tablet.

3. Disconnect all external devices from the tablet.

4. Remove the display assembly (see

Display assembly on page 19), and then remove the

following components:

a. WWAN module (see

WWAN module on page 26)

b. Power button board (see

Power button board on page 32)

c. Battery (see

Battery on page 39)

d. System board (see

System board on page 40)

Remove the slot cover:

1. Remove the four Phillips PM1.3×2.0 screws (1) that secure the slot cover retention bracket and spring

bracket to the bottom cover.

2. Remove the slot cover retention bracket (2) and the slot cover spring bracket (3).

Tablet component replacement procedures 45

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 72 73

Sin comentarios

HP ElitePad 1000 G2 Tablet Manual de usuario Pagina 51