HP JetAdvantage Security Manager 10 Device E-LTU Manual de usuario descargar pdf (Pagina 89)

General

Internet Protocol Security

IPsec/Firewall features provide network-layer security on IPv4 and IPv6 networks. The Firewall

provides simple control of IP addresses that are allowed access. IPsec provides the additional security

benefits of authentication and encryption. Whether traffic is allowed or dropped is determined by a

set of rules that make up the IPsec/Firewall policy. IPSec uses identity certificates in the device.

Consider installing CA signed certificates before enabling. Before enabling this item, you must fully

configure IPsec/Firewall on the device. You cannot remediate (disable) this policy item.

FIPS 140 Compliance Library

The Federal Information Processing Standards (FIPS 140) establish minimum cryptographic

requirements for software and hardware modules. Select the check box to assess whether FIPS 140 is

set on the device. If enabled, the following less secure settings are not allowed:

 MD5/DES/RC4 and earlier (use SHA1/AES instead)

 SSL 3.0 and earlier (use TLS 1.0 or higher instead)

 Web Encryption Strength set to Low or Medium (use High instead). If disabled, these

restrictions are removed, but current policy encryption settings are not modified.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 115 116

Sin comentarios

HP JetAdvantage Security Manager 10 Device E-LTU Manual de usuario Pagina 89