Hp ProLiant DL120 G7 Server Manual de usuario Pagina 28
- Pagina / 105
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Hardware options installation 28
Hardware options installation
Introduction
If more than one option is being installed, read the installation instructions for all the hardware options and
identify similar steps to streamline the installation process.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
Memory options
The server memory subsystem supports only UDIMMs.
The server supports dual-rank, PC3-10600E (DDR3) DIMMs operating at a speed of 1333 MHz.
Depending on the processor model and the number of DIMMs installed, the memory clock speed might be
reduced to 1066 or 800 MHz. For more information, see "General DIMM slot population guidelines (on
page 30)."
Memory subsystem architecture
The memory subsystem in this server is divided into channels. The processor supports two channels, and each
channel supports two DIMM slots, as shown in the following table.
Channel Slot Slot number
A
C
A
1
2
B
D
B
3
4
This server supports only UDIMMs.
DIMM slots in this server are identified by number and by letter. Letters identify the slots to populate for
specific memory modes. Slot numbers are reported by ROM messages during boot and for error reporting.
Single-rank and dual-rank DIMMs
DIMM configuration requirements are based on these classifications:
• Single-rank DIMM—One set of memory chips that is accessed while writing to or reading from the
memory.
• Dual-rank DIMM—Two single-rank DIMMs on the same module, with only one rank accessible at a time.
- HP ProLiant DL120 G7 Server 1
- User Guide 1
- Contents 3
- Contents 4 4
- Contents 5 5
- Contents 6 6
- Component identification 7
- Front panel LEDs 8
- Rear panel components 8
- Rear panel LEDs 9
- System board components 10
- System maintenance switch 11
- System board LEDs 11
- NMI functionality 12
- DIMM slot locations 12
- SAS and SATA drive LEDs 13
- BBWC module LEDs 14
- Fan locations 15
- T-10/T15 Torx screwdriver 16
- Operations 17
- Remove the access panel 18
- Install the access panel 18
- Remove the PCIe riser cage 18
- Install the PCIe riser cage 19
- Remove the air baffle 19
- Install the air baffle 20
- Operations 21 21
- Rack planning resources 22
- Optimum environment 22
- Temperature requirements 23
- Rack warnings 24
- Installing hardware options 25
- Setup 26 26
- Registering the server 27
- Introduction 28
- Memory options 28
- DIMM identification 29
- Memory configuration 30
- Installing a DIMM 30
- Drive options 31
- Removing a drive 32
- Optical drive option 33
- Expansion board option 36
- Storage controller option 37
- Remove the rear bracket 41
- Remove the ATX power supply 41
- Cabling 48
- Internal USB cabling 49
- BBWC battery cabling 50
- Optical drive cabling 51
- SATA cabling 51
- SAS cabling 52
- • SFF model 53
- Configuration and utilities 54
- Using RBSU 55
- Auto-configuration process 55
- Array Configuration Utility 56
- • Selecting the boot volume 57
- Management tools 58
- Diagnostic tools 59
- Integrated Management Log 60
- Keeping the system current 61
- ProLiant Support Packs 62
- Firmware 62
- HP Smart Update Manager 62
- Care Pack 63
- Troubleshooting 64
- Warnings and cautions 65
- Symptom information 66
- Loose connections 68
- Service notifications 68
- Server health LEDs 68
- Troubleshooting flowcharts 69
- General diagnosis flowchart 70
- Symptoms: 72
- Troubleshooting 74 74
- POST problems flowchart 75
- OS boot problems flowchart 77
- Troubleshooting 78 78
- • Redundancy failure 79
- (http://www.hp.com/support) 80
- Troubleshooting 81 81
- Battery 82
- FCC rating label 83
- Japanese class A notice 85
- BSMI notice 86
- Korean class A notice 86
- Chinese notice 86
- Laser compliance 86
- Battery replacement notice 87
- Electrostatic discharge 88
- Specifications 89
- Specification Value 90
- Support and other resources 91
- Customer Self Repair 93
- Reparo feito pelo cliente 95
- Acronyms and abbreviations 99
- Version Control Agent 101
- Documentation feedback 102
- Index 103 103
- Index 104 104
- Index 105 105
Relacionado con productos y manuales para Hardware De La Computadora Hp ProLiant DL120 G7 Server
Hardware De La Computadora Hp Server Management Packs for Microsoft System Cente Manual de usuario
(86 paginas)
(86 paginas)
Hardware De La Computadora Hp Планшетный ПК HP EliteBook Revolve 810 G1 Manual de usuario
(113 paginas)
(113 paginas)
(88 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.029 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales