Hp ProLiant ML350e Gen8 Server Manual de usuario descargar pdf (Pagina 26)

Operations 26

CAUTION: For proper cooling do not operate the server without the access panel, baffles,

expansion slot covers, or blanks installed.

To remove the component:

1. Do one of the following:

o For tower models, open and remove the bezel ("Remove the tower bezel" on page 22).

o For rack models, if installed, remove the security bezel (on page 24).

2. Power down the server (on page 22).

3. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

4. Do one of the following:

o For tower models, place the server on a flat, level surface with the access panel facing up.

o For rack models, extend the server from the rack (on page 27).

5. Remove the access panel:

a. Open the locking latch.

If the locking latch is engaged, use a T-15 Torx screwdriver to unlock it.

b. Slide the access panel back.

c. Lift and remove the access panel.

Install the access panel

NOTE: If the rack bezel was removed, install it before installing the access panel.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 146 147

Sin comentarios

Hp ProLiant ML350e Gen8 Server Manual de usuario Pagina 26