
Hardware options installation 56
3.
Remove the media blanks.
NOTE: HP recommends that you remove all media blanks to facilitate drive installation.
Store the blanks for later use.
Installing a half-height or full-height media device
You can install up to two half-height or one full-height removable media devices in the removable media
cage.
To install a half-height or full-height media device:
1. Power down the server (on page 20).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 21).
o Extend the server from the rack (on page 22).
3. Remove the access panel (on page 25).
4. Remove the removable media blanks ("Removing the removable media blanks" on page 55).
Comentarios a estos manuales