HP Elite 8300 Series Small Form Factor Especificaciones descargar pdf (Pagina 147)

HP-supplied isolation mounting screws are silver and blue. If you are replacing the primary hard

drive, you must remove the four silver and blue 6-32 isolation mounting guide screws from the

old hard drive and install them in the new hard drive.

Figure 7-14 Extra Guide Screw Locations

No. Guide Screw Device

1 Black M3 Metric Screws All Drives (except hard drives)

2 Silver and Blue 6-32 Isolation Mounting Screws Secondary Hard Drive

CAUTION: To prevent loss of work and damage to the computer or drive:

If you are inserting or removing a drive, shut down the operating system properly, turn off the

computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby

mode.

Before handling a drive, ensure that you are discharged of static electricity. While handling a drive,

avoid touching the connector.

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields

such as monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and

label the package “Fragile: Handle With Care.”

136 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 348 349

Sin comentarios

HP Elite 8300 Series Small Form Factor Especificaciones Pagina 147