HP B-series Embedded Switches Manual de usuario descargar pdf (Pagina 103)

Basic Security in FOS

103Fabric OS Procedures Version 3.1.x/4.1.x User Guide

Note: Setting the Boot PROM password requires accessing the boot prompt, which

stops traffic flow through the switch until the switch is rebooted.

1. Create a serial connection to the switch. If Secure Mode is enabled, connect to

the Primary FCS switch. If the switch does not have a serial port, contact

Technical Support.

a. Connect the serial cable to the serial port on the switch and to an RS-232

serial port on the workstation.

If the serial port on the workstation is RJ-45 instead of RS-232, remove

the adapter on the end of the serial cable and insert the exposed RJ-45

connector into the RJ-45 serial port on the workstation.

b. Disable any serial communication programs running on the workstation.

c. Open a terminal emulator application (such as HyperTerminal on a PC, or TERM

or Kermit in a Unix environment), and configure the application as follows:

In a Windows 95, 98, 2000, or NT environment:

In a UNIX environment, enter the following string at the prompt:

tip /dev/ttyb -9600

2. Reboot the switch by entering the reboot command.

3. Press ESC within four seconds after the message Press escape

within 4 seconds... displays.

The following options are available:

1) Start system.

2) Recovery password.

3) Enter command shell.

4. Enter “3” at the prompt to enter the command shell.

Parameter Value

Bits per second: 9600

Databits: 8

Parity: None

Stop bits: 1

Flow control: None

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 269 270

Sin comentarios

HP B-series Embedded Switches Manual de usuario Pagina 103