HP B-series Embedded Switches Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 270
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
Initial Configuration
15Fabric OS Procedures Version 3.1.x/4.1.x User Guide
7. At the Gateway Address prompt, enter the IP address of the gateway system if
applicable. Press the Enter key to continue.
The configuration is then committed to the switch firmware.
8. You are then prompted whether to make the IP address changes active now or
at the next reboot. Enter y at the prompt to have the IP address changes take
effect immediately.
The following example shows how to configure the IP address for a SAN Switch
2/16 using the ipaddrset command.
Example:
Configuring the Control Processor IP Addresses for the SAN Switch 2/32
The SAN Switch 2/32 has one Control Processor (CP) for which the Ethernet IP
and host information must be configured.
1. Have the following information available for the new switch:
Ethernet IP Address
Ethernet Subnetmask
—Hostname
Gateway IP Address
2. Log in to the switch as the admin user.
3. Enter the ipaddrset command at the command line. An interactive
session is opened.
4. Enter the Ethernet IP address and click Enter.
5. Enter the Ethernet Subnetmask and click Enter.
6. Enter the Hostname and click Enter.
7. Enter the Gateway IP Address and click Enter.
switch:admin> ipaddrset
Ethernet IP Address [10.32.53.136]:
Ethernet Subnetmask [255.255.240.0]:
Fibre Channel IP Address [none]:
Fibre Channel Subnetmask [none]:
Gateway Address [10.32.48.1]:
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 269 270

Comentarios a estos manuales

Sin comentarios