HP B-series Embedded Switches Manual de usuario descargar pdf (Pagina 222)

Troubleshooting

222 Fabric OS Procedures Version 3.1.x/4.1.x User Guide

Example:

Test a Switches Internal Components

To use the crossporttest command to test a switch’s internal

components:

1. Log into the switch as admin.

2. Enter the crossporttest -lb_mode 5 command.

Where 5 is the operand that causes the test to be run on the internal switch

components.

(This is a partial list. Refer to the HP StorageWorks Fabric OS Version

3.1.x/4.1.x Reference Guide for more information.)

Test Components To and From the HBA

1. Log into the switch as admin.

2. Enter the fPortTest command with the following operands (refer to the

HP StorageWorks Fabric OS Version 3.1.x/4.1.x Reference Guide for details).

[-spd_mode mode] Select the speed mode for the test.

[-ports itemlist] Specify a list of user ports to test.

switch:admin> crossporttest

Running Cross Port Test .... passed.

[-nframes count] Specify the number of frames to send.

[-lb_mode mode] Select the loopback point for the test.

[-spd_mode mode] Select the speed mode for the test.

[-ports itemlist] Specify a list of user ports to test.

[passCount] Specify the number of times (or number of

frames per port) to execute this test (default is

infinite or until you click Enter).

[port_number] Specify the port on which to run to test (F_Port

by default).

[payload_pattern] Specify the pattern of the test packets payload.

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 269 270

Sin comentarios

HP B-series Embedded Switches Manual de usuario Pagina 222