HP Proliant ML350 Generation 3 Guía de instalación Pagina 126

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 197
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 125
Cabling Guidelines
Connecting ATA or ATAPI Devices to the Integrated IDE Controller
This server includes one IDE cable (the Cable Select Cable) that can connect up to
two ATA or ATAPI devices to the system through the integrated IDE controller. This
cable has three clearly labeled connectors. If only one IDE device is connected to the
system, it must be secured to the cable connector labeled Drive 0. All IDE devices in
the system should have their configuration jumpers set to “Cable Select” or “CS.”
IMPORTANT: If your network operating system is Novell NetWare, HP recommends that you
connect your CD-ROM to the primary IDE channel and to the Drive 0 connector on the IDE
cable.
NOTE: ATA (IDE) hard drives are not supported.
4-12 HP ProLiant ML350 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: e-ch4 Cabling Guidelines.doc
Codename: Steel Venom Part Number: 316354-001 Last Saved On: 12/9/02 8:20 AM
Vista de pagina 125
1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 196 197

Comentarios a estos manuales

Sin comentarios