HP Proliant ML350 Generation 3 Guía de usuario descargar pdf (Pagina 25)

Setup 25

person may be required to help align the server if the server is installed higher than

chest level.

• Use caution when installing the server in or removing the server from the rack; it is

unstable when not fastened to the rails.

CAUTION: Always plan the rack installation so that the heaviest item is on the bottom of the rack. Install

the heaviest item first, and continue to populate the rack from the bottom to the top.

1. Install the server and cable management arm into the rack. Refer to the installation instructions that

ship with the 3-7U Quick Deploy Rail System.

2. Install an additional extender bracket (included with the server) to the cable management arm. Refer

to "Converting the cable management arm swing" in the installation instructions that ship with the 3-

7U Quick Deploy Rail System.

3. Connect peripheral devices to the server ("Rear panel components" on page 8).

4. Connect the power cord to the rear of the server.

5. Connect the power cord to the AC power source.

Powering up and configuring the server

To power up the server, press the Power On/Standby button.

While the server boots, RBSU and the ORCA utility are automatically configured to prepare the server for

operating system installation.

To configure these utilities manually:

• Press the F8 key when prompted during the array controller initialization to configure the array

controller using ORCA.

• Press the F9 key when prompted during the boot process to change the server settings using RBSU.

The system is set up by default for the English language.

For more information on the automatic configuration, refer to the HP ROM-Based Setup Utility User Guide

located on the Documentation CD.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 105 106

Sin comentarios

HP Proliant ML350 Generation 3 Guía de usuario Pagina 25