HP Proliant ML350 Generation 3 Guía de usuario descargar pdf (Pagina 56)

Cabling 56

connectors. If only one IDE device is connected to the system, it must be secured to the cable connector

labeled Drive 0. For all IDE devices, set the configuration jumpers to "Cable Select" or "CS."

IMPORTANT: If the network operating system is Novell NetWare, HP recommends that you connect the

CD-ROM to the primary IDE channel and to the Drive 0 connector on the IDE cable.

NOTE: ATA (IDE) hard drives are not supported.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 105 106

User Guide 1
Audience assumptions 2
Contents 3
Contents 4 4
Contents 5 5
Component identification 6
Front panel LEDs and buttons 7
Rear panel components 8
Rear panel LEDs and buttons 9
System board components 10
System maintenance switch 11
NMI jumper 11
System board LEDs 12
SAS and SATA hard drive LEDs 14
Operations 16
Operations 17 17
Remove the access panel 18
Install the access panel 19
In this section 20
Optimum environment 21
Temperature requirements 22
Power requirements 22
Rack planning resources 23
Rack warnings 23
Installing hardware options 24
Setting up a tower server 24
Registering the server 26
Introduction 27
Processor option 27
Memory options 34
Installing FBDIMMs 35
Hard drive options 36
SATA or SAS hard drive 37
Identifying guide screws 39
Installing a diskette drive 42
Expansion board options 44
Remove the air baffle 49
Cabling 55
Cabling 56 56
Configuration tools 57
ROM-Based Setup Utility 58
BIOS Serial Console 59
Array Configuration Utility 59
Management tools 60
ROMPaq utility 61
Erase Utility 62
Management Agents 62
HP Systems Insight Manager 62
Redundant ROM support 62
USB support 63
Diagnostic tools 64
Keeping the system current 64
ProLiant Support Packs 65
Care Pack 65
Troubleshooting 66
Symbols on equipment 67
Warnings and cautions 67
Symptom information 68
Loose connections 69
Service notifications 69
Troubleshooting flowcharts 70
General diagnosis flowchart 71
Symptoms: 73
Troubleshooting 75 75
POST problems flowchart 76
OS boot problems flowchart 77
Troubleshooting 79 79
Possible causes: 80
Redundancy failure 80
Troubleshooting 81 81
Battery replacement 83
FCC rating label 84
FCC logo, United States only 85
Modifications 86
Japanese notice 87
BSMI notice 87
Korean notice 88
Laser compliance 88
Battery replacement notice 88
Electrostatic discharge 90
Server specifications 91
Technical support 93
Customer Self Repair 94
Technical support 96 96
Reparo feito pelo cliente 97
Technical support 98 98
Technical support 99 99
Technical support 100 100
Acronyms and abbreviations 101
Systems Insight Manager 103
Index 104 104
Index 105 105
Index 106 106

Comentarios a estos manuales

Sin comentarios

HP Proliant ML350 Generation 3 Guía de usuario Pagina 56

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores HP Proliant ML350 Generation 3