HP Proliant ML350 Generation 3 Guía de usuario descargar pdf (Pagina 43)

Hardware options installation 43

Slide the diskette drive into the diskette drive bay.

8. Connect the data and power cables to the rear of the device.

9. Connect the diskette drive cable to the diskette drive cable connector on the system board ("System

board components" on page 10).

10. Install the access panel (on page 19).

11. Do one of the following:

• Close or install the tower bezel, as needed.

• Slide the server back into the rack.

12. Power up the server (on page 16).

Redundant hot-plug power supply option

WARNING: To reduce the risk of personal injury or damage to the equipment, the

installation of power supplies should be performed only by individuals who are qualified

in servicing server equipment and trained to deal with products capable of producing

hazardous energy levels.

WARNING: To reduce the risk of personal injury from hot surfaces, observe the thermal

labels on each power supply or module.

WARNING: To reduce the risk of injury from electric shock hazards, do not open power

supplies. Refer all maintenance, upgrades, and servicing to qualified personnel.

CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that you are properly

grounded (earthed) before beginning any installation procedure.

To install the component:

1. Identify the redundant power supply bay ("Rear panel components" on page 8).

IMPORTANT: Power supplies for the model shown are hot-pluggable. When using the redundant power

supply option, it is not necessary to power down the server before removing or installing a power supply.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 105 106

Sin comentarios

HP Proliant ML350 Generation 3 Guía de usuario Pagina 43