HP SuperStack 3 Load Balancer Appliance Manual de usuario descargar pdf (Pagina 38)

38 CHAPTER 4: WORKING WITH THE WEB INTERFACE

Setting up SNMP

Management

You can manage a Server Load Balancer using any Network Manager

running the Simple Network Management Protocol (SNMP), such as

3Com Network Supervisor software.

Specifying

Community Strings

You can specify SNMP community strings for the users defined on the

Server Load Balancer.

To specify the community strings, complete the following steps:

1 Click Device View on the Toolbar.

2 Select System > Management > Community Strings in the Navigation

Tree. The Community Strings window is displayed.

3 The Get Access Community String field is defaulted to public.

4 Select Set Access Enabled check box. This enables the access to the Server

Load Balancer. The Set Access Community String is defaulted to private.

5 Click OK.

Modifying a Trap

Address

You can modify a trap address and its community string. The Server Load

Balancer supports the following traps:

To modify a trap address, complete the following steps:

1 Click Device View on the Toolbar.

2 Select System > Management > Trap Address in the Navigation Tree. The

Modify Trap Address page appears. This page lists the ID, IP Address and

the Community String.

3 Click on 2. The line becomes highlighted.

4 Click Modify. The Trap Address window appears.

5 The Trap Community String field is defaulted to public.

6 Enter 1.1.1.1 in the Trap IP Address field. The IP address you enter

should be the destination for this trap.

7 Click OK and close out of the Modify Trap Address page. You have now

modified the trap community string and the trap IP address.

■ Cold Start ■ Spanning Tree newRoot

■ Authentication Failure ■ Spanning Tree topologyChange

■ Link Up/Down ■ RMON Event

slb_gsg.bk Page 38 Thursday, May 31, 2001 8:57 AM

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 98 99

Sin comentarios

HP SuperStack 3 Load Balancer Appliance Manual de usuario Pagina 38