Hp 3PAR Operating System Software Manual de usuario Pagina 254

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 289
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 253
Quick Setup: RCFC Transport Layer
Table 9 Quick Setup Steps for RCFC
Backup SystemPrimary SystemReferenceStep
controlport offline
<N:S:P>
controlport offline
<N:S:P>
“Setting Up Remote-Copy
Interface for RCFC” (page
36)
1. Take the port offline.
controlport config
rcfc -ct point -f
<N:S:P>
controlport config
rcfc -ct point -f
<N:S:P>
“Setting Up Remote-Copy
Interface for RCFC”
(page 36)
2. On all RCFC ports, set up
the interface.
showport -rcfcshowport -rcfc3. On all RCFC ports, get
RCFC port positions.
showrctransport -rcfccontrolport rcfc
init -f <N:S:P>
4. On each RCFC port,
initialize port.
controlport rcfc init
-f <N:S:P>
showrctransport -rcfcshowrctransport
-rcfc
5. On each RCFC port,
verify port is ready
a. cli checkrclink
startserver
<N:S:P>
<dest_addr>
“Checking RCFC Link
Throughput and Latency”
(page 38)
6. On all nodes, check the
links.
b. cli checkrclink
startclient
<N:S:P>
<dest_addr> <time>
c. cli checkrclink
stopserver <N:S:P>
Quick Setup: Remote-Copy Configurations
“Quick Setup Steps for Unidirectional Pairs: 1-to-1, N-to-1,
and 1-to-N Configurations” (page 255)
1-to-1 Unidirectional
“Quick Setup Steps for the Bidirectional Pair: 1-to-1, N-to-1,
and 1-to-N Configurations” (page 256)
1-to-1 Bidirectional
“Quick Setup Steps for Unidirectional Pairs: 1-to-1, N-to-1,
and 1-to-N Configurations (page 255) for each remote-copy
pair (4 max primary:1 backup).
N-to-1
Table 11 (page 256) for one remote-copy pair if desired.
“Quick Setup Steps for Unidirectional Pairs: 1-to-1, N-to-1,
and 1-to-N Configurations (page 255) for each remote-copy
pair (1 primary:2 max backup).
1-to-N
Table 11 (page 256) for one remote-copy pair if desired.
“Quick Setup Steps for Synchronous Long Distance
Configurations” (page 257)
SLD
NOTE: If you use a script to set up the remote-copy configuration, keep in mind that it takes some
time to establish the TCP/IP connections after the creatercopytarget and admitrcopylink
commands. It can take as long as two minutes for the links to be marked Up and the target marked
ready.
254 Quick Setup Guide
Vista de pagina 253
1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 288 289

Comentarios a estos manuales

Sin comentarios