Hp 3PAR Operating System Software Manual de usuario descargar pdf (Pagina 53)

3. On the primary system (System1), add the pre-existing virtual volumes to the newly created

volume group by issuing either of the following commands:

# admitrcopyvv <VV_name> <group_name> <target_name>:<sec_VV_name>

where:

• <VV_name>—Name of the virtual volume (for example, vv1) to add to the primary

volume group on the primary system

• <group_name>—Name of the primary volume group (Group1) on the primary system

• <target_name>—Name of the target system (System2)

• <sec_VV_name>—Name of the corresponding secondary virtual volume on the target

system (vv1_remote)

or:

# admitrcopyvv -pat <pattern> <group_name> <target_name:sec_VV_name>

where <pattern> represents the pattern of virtual volume names (for example, vv*)

To admit secondary volumes with the same names as their primary virtual volume counterparts,

use the @vvname@ wildcard instead of sec_VV_name. For example:

# admitrcopyvv -pat <pattern> <group_name> <target_name>:@vvname@

The admitrcopyvv command:

• Adds the specified virtual volume (vv1) to the primary volume group (Group1) on the

primary system (System1).

• Adds the specified virtual volume (vv1_remote), which you have already verified to

exist on the target system (System2), to the corresponding secondary volume group on

the target system (System2).

Because HP 3PAR Remote Copy created this secondary volume group (Group1.r112)

when you created the primary volume group (see “Creating Volume Groups for

Unidirectional Remote Copy” (page 82)), HP 3PAR Remote Copy automatically adds

vv1_remote to Group1.r112.

HP 3PAR Remote Copy can also automatically create target volumes on the target volume

group. To create target volumes automatically, use the admitrcopyvv -createvv

command. For more information, see Automatically Creating Target Volumes on the

Secondary System.

SolutionProblem

To redo volume groups that

were created with the wrong

name, direction, or mode:

1. Use the removercopygroup command.

2. Repeat the setup from Step 1.

To redo virtual volumes that

were incorrectly placed in

primary or secondary system.

1. Use the dismissrcopyvv command.

2. Repeat the setup from Step 3.

For more information about these commands, see “About the Remote-Copy

Commands” (page 261).

Creating Volume Groups for M-to-N Remote Copy 53

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 288 289

Comentarios a estos manuales

Sin comentarios

Hp 3PAR Operating System Software Manual de usuario Pagina 53

Comentarios a estos manuales

Relacionado con productos y manuales para Almacenamiento Hp 3PAR Operating System Software