Hp ESL E-series Tape Libraries Manual de usuario Pagina 30
- Pagina / 141
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Space requirem
ents
In addition to the space required for standalone libraries, a CLM library requires 52 inches (130 cm)
of clear space t
o the left of the primary cabinet as you face the front of the cabinets. See the section
called Floor space in HP StorageWorks ESL E-Series Tape Library unpacking and installation guide
for fur ther information.
System components
NOTE:
TheprimarycabinetofaCrossLinkedLibrarymustbeanESL712eor630e,oranESL322eor286e
that has already been expanded to full capacity using purchased licenses installed using Command
View TL. Secondar y cabinets must b e ESL 712e or 630e libraries.
The primary cabinet must have between 1 and 5 fully-populated clusters (that is, each of these clusters
must contain 4 drives). Cabinet 2 in the library must have at least 1 drive cluster containing at least 1
drive, and may have up to 6 fully-populated clusters. Other secondary cabinets must have at least 1 drive
cluster containing at least 1 drive, and may have up to 2 fully-populated drive clusters. The entire library
can have up to 11 clusters and up to 44 drives. Maximum slot count in a 5 cabinet library is 3,560.
Cross Linked systems contain the following additional parts:
• Cross Link arm (CLM arm)
• Cross Link robotics controller (CLM robotics controller)
The CLM arm (see Figure 14) is used to send a shuttle between libraries. The shuttle carries a data tape
cartridge so that it can be stored in a secondary cabinet or retrieved for use, as necessary.
10667
Figure 14 CLM arm
The CLM robotics controller (see Figure 15) is located on the primary library only, just above the cabinet
controller. In an individual library, this would be considered the number 5 drive bay. The controller
contains the power supplies, CLM electronics PWA, and Ethernet hub for the CLM robotics. It supplies
power to and controls the CLM.
30
Library overview
- HP StorageWorks 1
- ESL E-Series Ta 1
- Legal and notice information 2
- Contents 3
- About this guide 11
- HP technical support 12
- Subscription service 12
- Other HP web sites 12
- HP-authorized reseller 12
- 1Libraryoverview 13
- Back panel 14
- Library robotics 16
- Switch for the i 18
- Tape drives 18
- Tape cartridges 19
- Ultrium tape ca 20
- Load ports and magazines 21
- Card cage and controllers 22
- 1 2 3 4 5 6 8 24
- 1 2 3 4 5 6 7 8 9 24
- L A N-free backup and restore 26
- SCSI over IP Protocol (SIPP) 27
- Interface Manager card 27
- Cross Linked libraries 29
- Space requirem 30
- System components 30
- #1 Phillips screws 31
- Lock Element Addressing 32
- Ultrium library 36
- SDLT library 38
- Mixed media library 40
- Library overview 42
- 2 Lib rary operations 43
- WARNING! 44
- Preparing tape cartridges 45
- Ultrium bar code labels 46
- SDLT ba r cod e labels 47
- Media label identifiers 48
- Setting the writ 49
- Inserting tape cartridges 50
- Powering on the library 51
- Using the OCP 52
- Home screen 53
- OCP buttons 54
- OCP components 55
- Menu screen 57
- Library operations 58
- View ing 61
- Viewing the event log 64
- Load Ports screen 65
- Operations screen 66
- Using removable magazines 70
- Insert removable magazines 71
- Remove re 72
- Start-up problems 73
- OCP problems 74
- Robotics problems 74
- Operating problems 75
- Switch problems 76
- Tape drive problems 77
- Status LED diagnostic codes 78
- Networklinkactivity/speedLEDs 78
- Interface Ma 79
- LED indicators 80
- 5678 3 1 81
- 5678 4 3 2 1 81
- Basic troubleshooting 82
- Verifying SCSI b 83
- Maintaining tap 85
- Cleaning Ultrium tape drives 86
- A Library characteristics 87
- Environmental speci fications 88
- Library characteristics 90
- B Rel ocating the library 91
- Removing tape car tridges 92
- (see Figure 58) 93
- 5. Insta 94
- 6. Instal 95
- Disconnecting library cables 99
- Crating the library 100
- Preparing the li 102
- C Regulatory sta temen ts 103
- Laser sta 104
- Luokan 1 laserlaite 105
- Laser klasse 1 105
- Appareil à laser de classe 1 105
- Producto láser de clase 1 105
- Battery stateme 106
- Waste Electr 107
- Regulatory statements 108
- D Sense data values 113
- ASC ASCQ 114
- Message name / description 114
- Messag e name / description 115
- EEventreporting 123
- Event ID 124
- Critical events 124
- Warning event 126
- Table 24 Warning events 127
- Warning events 127
- Informatio 128
- Table 25 Information events 129
- Information event 129
- Event reporting 134
- Glossary 135
Relacionado con productos y manuales para Almacenamiento Hp ESL E-series Tape Libraries
Almacenamiento Hp X500 Data Vault Manual de usuario
(331 paginas)
(331 paginas)
Almacenamiento Hp OpenView Storage Management Appliance and Software Manual de usuario
(146 paginas)
(146 paginas)
Almacenamiento Hp XP7 Storage Manual de usuario
(208 paginas)
(208 paginas)
Almacenamiento Hp XP P9500 Storage Manual de usuario
(116 paginas)
(116 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.031 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales