
10636
Figure 17 CLM motor assemb ly
Lock Element Addressing
Lock Eleme
nt Addressing should be used on a CLM library with 3 or more cabinets. When enabled,
Lock Eleme
nt Addressing ensures tha t if a secondary c abinet goes off-line, locations and counts of
drives, h
osts, and all other elements in the remaining cabinets stay the same. If a c abinet fails when this
feature i
s disabled, these elements will likely change.
To enable or disable Lock Element Addressing:
1. From the OCP of the primary cabinet, select Menu,thenSetup.
2. From the Setup screen, select Loc k Element Addressing.
3. Use the U
p and Down arrows to highlight Enabled or Disabled,thepressSe lect.
Disable
Lock Element Addressing in order to change locked elements such as load ports, number of
drives
,ornumberofcabinets.
Library storage locations and slot numbering
The HP StorageWorks ESL E-Series standalone tape library is an automated tape storage and retrieval
library that may consist of up to 24 tape drives and up to 718 Ultrium tape cartridges, or 636 SDLT tape
cartridges, or a combination of Ultrium and SDLT tape cartridges in a mixed-media system.
NOTE:
CLM libraries have different storage capacities and requirements depending on how many cabinets are
in the library, among other considerations. Due to the number of variations possible, slot numbering
for CLM libraries is not provided. The panel and general slot information presented here does apply
to each cabinet within a CLM library.
The library stores tape cartridges in the following locations:
• Left panels
• Right panels
• Back panels
32
Library overview
Comentarios a estos manuales