Hp StorageWorks 2405 Disk System Manual de usuario descargar pdf (Pagina 119)

Removal and Replacement 119

Removal and Replacement

7 Set address switches on the new LCC to match settings on the peer LCC.

Caution The address switches must have the same settings on both LCCs.

8 Open the cam levers (see Figure 58) by pulling them away from the center of

the card.

9 Insert the LCC in the empty slot.

10 Push the cam levers flat against the center of the card to seat the LCC pins

firmly on the midplane.

11 Watch the LCC Fault LED (see Figure 59). It should come on briefly and then

turn off. If the LED stays on and a buzzer sounds, the switch settings do not

match the settings on the peer LCC. For other solutions to a LCC fault, see

“Isolating Causes” in chapter 4.

12 Tighten the locking screws (A in Figure 58).

13 Reattach the FC cables.

Caution The LCC must be replaced or a filler panel installed in the open

slot to ensure proper cooling for the disk system.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 143 144

Sin comentarios

Hp StorageWorks 2405 Disk System Manual de usuario Pagina 119