Hp ProLiant DL360p Gen8 Server Manual de usuario Pagina 88
- Pagina / 118
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Software and configuration utilities 88
NOTE: The server ships with the same version programmed on each side of the ROM.
Safety and security benefits
When you flash the system ROM, ROMPaq writes over the backup ROM and saves the current ROM as a
backup, enabling you to switch easily to the alternate ROM version if the new ROM becomes corrupted for
any reason. This feature protects the existing ROM version, even if you experience a power failure while
flashing the ROM.
Keeping the system current
Drivers
IMPORTANT: Always perform a backup before installing or updating device drivers.
The server includes new hardware that may not have driver support on all OS installation media.
If you are installing an Intelligent Provisioning-supported OS, use Intelligent Provisioning (on page 80) and its
Configure and Install feature to install the OS and latest supported drivers.
If you do not use Intelligent Provisioning to install an OS, drivers for some of the new hardware are required.
These drivers, as well as other option drivers, ROM images, and value-add software can be downloaded as
part of an SPP.
If you are installing drivers from SPP, be sure that you are using the latest SPP version that your server
supports. To verify that your server is using the latest supported version and for more information about SPP,
see the HP website (http://www.hp.com/go/spp/download).
To locate the drivers for a particular server, go to the HP website (http://www.hp.com/go/hpsc) and click
on Drivers, Software & Firmware. Then, enter your product name in the Find an HP product field and click
Go.
Software and firmware
Software and firmware should be updated before using the server for the first time, unless any installed
software or components require an older version.
For system software and firmware updates, use one of the following sources:
• Download the SPP ("HP Service Pack for ProLiant" on page 82) from the HP Service Pack for ProLiant
download page (http://www.hp.com/go/spp).
• Download individual drivers, firmware, or other systems software components from the server product
page in the HP Support Center (http://www.hp.com/go/hpsc).
Version control
The VCRM and VCA are web-enabled Insight Management Agents tools that HP SIM uses to schedule
software update tasks to the entire enterprise.
- User Guide 1
- Contents 3
- Contents 4 4
- Contents 5 5
- Component identification 7
- • 4 LFF 8
- • 10 SFF 8
- Front panel LEDs and buttons 9
- Rear panel components 10
- Rear panel LEDs and buttons 11
- System board components 12
- DIMM slots 13
- System maintenance switch 14
- NMI jumper 14
- Systems Insight Display LEDs 15
- Device numbers 17
- Fan modules 18
- Component identification 19 19
- Operations 20
- 10 SFF configuration 22
- Remove the access panel 23
- Install the access panel 23
- Remove the PCI riser cage 24
- Install the PCI riser cage 25
- Optimum environment 27
- Temperature requirements 28
- Power requirements 29
- Rack warnings 30
- Installing hardware options 31
- Registering the server 34
- Introduction 35
- Remove the heatsink blank: 36
- Caged heatsink blank 36
- Screw-down heatsink blank 36
- Caged heatsink 40
- Screw-down heatsink 40
- Memory options 42
- HP SmartMemory 44
- DIMM identification 46
- Memory configurations 46
- Online spare population 48
- Installing a DIMM 49
- 1. Remove the drive blank 51
- 2. Prepare the drive 51
- Controller options 56
- Front video adapter option 58
- FlexibleLOM option 59
- Expansion board option 61
- 48V DC power supply option 64
- Replace the safety cover 67
- Rack bezel option 68
- Cabling 72
- Chipset SATA cable option 73
- Cabling 75 75
- FBWC capacitor pack cabling 77
- Server mode 78
- HP product QuickSpecs 78
- HP iLO Management 78
- Active Health System 79
- Intelligent Provisioning 80
- HP Insight Diagnostics 81
- Erase Utility 81
- HP Service Pack for ProLiant 82
- HP ROM-Based Setup Utility 83
- Boot options 84
- Configuring AMP modes 84
- Utilities and features 85
- ROMPaq utility 87
- Automatic Server Recovery 87
- USB support 87
- Redundant ROM support 87
- Keeping the system current 88
- ProLiant servers 89
- Troubleshooting 90
- System battery 91
- System battery 92 92
- Regulatory information 93
- Warranty information 94
- Electrostatic discharge 95
- Specifications 96
- (94% efficiency) 100
- Support and other resources 103
- Customer Self Repair 105
- Reparo feito pelo cliente 107
- Acronyms and abbreviations 111
- Documentation feedback 114
- Index 115 115
- Index 116 116
- Index 117 117
- Index 118 118
Relacionado con productos y manuales para Hardware De La Computadora Hp ProLiant DL360p Gen8 Server
(139 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.066 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales