Hp ProLiant ML570 G4 Server Manual de usuario Pagina 60
- Pagina / 125
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Hardware options installation 60
10.
Remove the system board.
11. Remove the tape drive blank ("Unlock and remove the tower bezel" on page 25).
NOTE: Most devices have holes designed to correspond with the wire retainers that are installed in the
upper slot of the guide clips. For devices that have holes designed to correspond to the lower slot of the
guide clip, the wire retainer must be removed and reinstalled in the lower slot of the clip.
12. If the device has holes that correspond to the lower slot, adjust the wire retainers on both sides of the
device:
a. Push the wire retainer from behind to remove the wire retainer from the upper slot.
b. Install the wire retainer in the lower slot. Be sure the wire retainer is snapped into place before
installing on a media device.
13. Attach the plastic guides to the tape drive:
NOTE: The plastic clips and the wire retainers are located inside the tape drive blank. Each plastic clip is
labeled with an "L" for left or an "R" for right.
a. Align the left plastic clip to the drive.
b. Insert the wire retainer into the hole closest to the front of the drive on the left side.
c. Slide your finger along the wire retainer until the other side of the wire retainer snaps into place
in the back of the tape drive.
- User Guide 1
- Audience assumptions 2
- Contents 3
- Contents 4 4
- Contents 5 5
- Contents 6 6
- Component identification 7
- Front panel LEDs and buttons 8
- Rear panel components 9
- Rear panel LEDs and buttons 10
- System board components 11
- System maintenance switches 12
- NMI switch 13
- LED illuminates amber 14
- SAS and SATA device numbers 15
- SAS and SATA hard drive LEDs 16
- DIMM slots 20
- Hot-plug power supply LEDs 20
- Hot-plug fans 21
- Hot-plug fan LEDs 22
- Operations 23
- Operations 24 24
- Operations 25 25
- 2. Open the bezel 25
- Remove the rack bezel 26
- Remove the access panel 27
- Install the access panel 27
- Rack planning resources 29
- Optimum environment 29
- Temperature requirements 30
- Power requirements 30
- Rack warnings and cautions 31
- Installing hardware options 32
- Setting up a tower server 33
- Setup 36 36
- Registering the server 37
- Processor option 38
- Memory options 43
- Single- and Dual-rank DIMMs 44
- Advanced ECC Memory 44
- Online spare memory 45
- Hot-plug mirrored memory 46
- Memory boards and DIMMs 47
- Configuring the memory 53
- ROM-based diagnostics 54
- Selecting the AMP mode 54
- Prepare the hard drive 55
- Drive options 57
- Removable media devices 58
- Redundant hot-plug fans 63
- Replacing hot-plug fans 64
- Expansion board options 65
- Installing expansion boards 66
- Tower-to-rack conversion 67
- Removing the casters 68
- Removing the tower cover 69
- Installing the rack bezel 69
- Rack-to-tower conversion 71
- Removing the server rails 73
- Installing the tower cover 73
- Installing the casters 74
- Installing the tower bezel 74
- Cabling 76
- SAS cabling 77
- Video connector cabling 77
- Cabling 78 78
- Configuration tools 79
- HP ROM-Based Setup Utility 80
- Array Configuration Utility 81
- Management tools 82
- Management Agents 83
- Redundant ROM support 83
- USB support 83
- HP Systems Insight Manager 83
- Diagnostic tools 84
- Keeping the system current 85
- Care Pack 86
- Troubleshooting 87
- Symbols on equipment 88
- Warnings and cautions 88
- Symptom information 89
- Loose connections 90
- Service notifications 90
- Troubleshooting flowcharts 91
- General diagnosis flowchart 92
- Symptoms: 94
- Troubleshooting 96 96
- POST problems flowchart 97
- OS boot problems flowchart 98
- Troubleshooting 100 100
- Possible causes: 101
- Redundancy failure 101
- Troubleshooting 102 102
- Electrostatic discharge 103
- In this section 104
- FCC rating label 104
- FCC logo, United States only 105
- Modifications 106
- Japanese notice 107
- BSMI notice 107
- Korean notice 108
- Laser compliance 108
- Battery replacement notice 108
- Specifications 110
- Technical support 112
- Customer self repair 113
- Customer Self Repair 114
- Technical support 115 115
- Reparo feito pelo cliente 116
- Technical support 117 117
- Technical support 118 118
- Technical support 119 119
- Acronyms and abbreviations 120
- Version Control Agent 122
- Wake-on LAN 122
- Index 123 123
- Index 124 124
- Index 125 125
Relacionado con productos y manuales para Hardware De La Computadora Hp ProLiant ML570 G4 Server
(109 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales