HP Data Center Environmental Edge Manual de instalación descargar pdf (Pagina 27)

HP Environmental Base Station installed on a CRAH/CRAC 27

HP recommends using cable tie wraps to secure the base station to an available support bracket.

2. Connect the data transfer cable from the HP Plenum Rated Sensor Array to the base station.

3. After all hardware is installed, power up the components ("Power up procedure" on page 70).

Installation is complete.

Single CRAH installation diagram

Callout Component Description

CRAH return air stream The return air side of the CRAH

CRAH supply air stream The supply air side of the CRAH

Base station The base station is mounted on the supply air side of the CRAH.

Supply side of plenum array The three-point plenum array that measures the supply air temperature

and humidity.

Return side of plenum array The three-point plenum array that measures the return air temperature

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 81 82

Sin comentarios

HP Data Center Environmental Edge Manual de instalación Pagina 27