HP Data Center Environmental Edge Manual de instalación descargar pdf (Pagina 35)

(Optional) Sensor Base Stations 35

Remove the mounting tape liner, and secure the base station to the desired location on the top of the

rack.

3. Remove the mounting tape liner, and secure the door position wire harness to the rack door.

4. Connect the Door Position Base Station to the door sensors.

a. Strip the plastic coating from the ends of the two door sensor wires.

b. Strip the plastic coating from the ends of the two wires on the Door Position Base Station wire

harness.

NOTE: If you are only installing one door position sensor, connect the second wire to the Door

Position Base Station. If you are installing the door position sensors in a daisy chain fashion,

connect the second wire to the next door position sensor.

c. Using a wire screw, twist together one wire from the door sensor with one wire from the Door

Position Base Station wire harness.

Repeat steps a through c for the other wire.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

Sin comentarios

HP Data Center Environmental Edge Manual de instalación Pagina 35