HP Data Center Environmental Edge Manual de instalación descargar pdf (Pagina 52)

(Optional) Sensor Base Stations 52

If a flat surface is available, remove the mounting tape liner and secure the base station to the

surface.

b. If a support bracket is available, use cable ties to secure the base station to the support bracket.

2. Connect the 200A Current Base Station to your current sensor.

a. Strip the plastic coating from the ends of the two wires on the wire harness labeled CH 3/Current

b. Using a flathead screwdriver, secure the white wire to the positive terminal block on the current

sensor transducer.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 81 82

Sin comentarios

HP Data Center Environmental Edge Manual de instalación Pagina 52