HP 2000CP 2500CP Manual de usuario descargar pdf (Pagina 138)

Service Calibrations

5-17

HP DesignJet CP Series Printers

C08. Service Accuracy

The purpose of this calibration is to calibrate the nominal advance of the

media. This calibration is necessary to control the exact movement of the

media in order to avoid print quality problems like banding.

Perform the Service Accuracy calibration whenever:

 Banding is detected in prints.

 Carriage is disassembled or replaced.

 X-axis Assembly is disassembled or replaced.

 Drive Roller is disassembled or replaced.

 Misalignment between colors is detected.

 Electronics Module is replaced.

Remove any media already loaded into the Printer before

performing the calibration.

Perform the Service Accuracy Calibration as follows:

MAKE SURE THAT THE WINDOW IS CLOSED BEFORE YOU

PERFORM THIS CALIBRATION.

1 In the Calibrations submenu, scroll to “C8 Service Accuracy” and press

Enter.

Calibrations

C8 Service Accuracy

2 The “Create pattern / Measure pattern” message is displayed.

3 Press the Up Arrow key to select “Create pattern”.

4 The “Status / Calibrating” message is displayed while the Printer is

calibrating.

5 When the Printer has finished calibrating, the “Load media for

calibration” message is displayed.

You must use HP Matte film to perform this calibration even if

it is not supported. You can select it as any media in the

front-panel.

6 Load the media. If using D-size media, load the short edge as the leading

edge in D-size Printers and the long edge as the leading edge in E-size

Printers.

The calibration is continued on the next page.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 347 348

Sin comentarios

HP 2000CP 2500CP Manual de usuario Pagina 138